Waterproof DW PixelPro LED Rectangle Modules combine 3 DW LEDs with an intelligent WS2801 integrated circuit chip, to produce eye catching animated effects. With one IC chip per module, the performance and control of these modules is like nothing you have ever seen. We conducted extensive testing on a number of IC chips and chose the best one on the market. The WS2801 chip provides the widest range of colors, is faster, more efficient, and overall performs better than other IC chips.
Easy to customize and control when used with the DMX512 Pixel Decoder
. Compatible with standard DMX output, the DMX512-PX-2801 can be used with a DMX controller or light board control system of your choice. The DMX512-PX-2801 converts standard DMX output into serial protocol for the WS2801 chip, thereby enabling control of each module.
Each Warm White LED Rectangle Module is individually addressable, so you can set the brightness of each module on a string independent of one another. With three LEDs in each rectangle, these intelligent modules can be used to easily create vivid eye catching effects. Design lighting effects for large displays that were never thought possible. The ability to control the dimming of each module individually creates an endless number of scenarios for creative lighting design, especially back lighting. This is the beauty of pixel control.
The PixelPro Rectangle Modules are made in 20-module chains, with connector plugs on the input and output of full strings. Modules strings can be easily linked at the beginning and end using the built in connectors. PixelPro modules are one directional, so be sure pay attention to the orientation of the string. Female plug is always the input, male output. The input direction is always indicated by an arrow. This product is not waterproof when cut and the SM connectors are not waterproof.
Easy to install: Built in double sided adhesive on the back. Just cut, peel, and stick. 20 cm (about 8 inches) of wire between modules. Simply cut and splice the wire wherever you like. Because the wire is flexible, you can array your modules around your installation as you wish. If you have dark spots, you can reposition at will. Modules can be easily linked at the beginning or end.
- Epoxy-encased plastic package.
- Inputs: GND, DI, CI, +12V
- Daylight White (6500° Kelvin.)
- IP65 waterproof.
- 12 volts DC.
- 0.54 watts (10.8 watts/string.)
- Length: 2.9 in = 74 mm.
- Width: 0.55 in = 14 mm.
- Height: 0.39 in = 10 mm.
- LED spacing: 1 in = 25.4 mm.
- Cuttable between modules.
- RoHS, IP65.
- 50,000 hours expected lifetime.
- Warranty: 3 years limited.
- No Ultra-Violet emissions, so it won't harm your art or documents.
- We use high quality LEDs for maximum color vibrancy, longevity and color rendering. We pay more for our LED components, and you'll benefit from the difference. This is not a commodity product. Quality matters, and the materials, controls, connections and tech support we provide will make your project successful.
- Cut LED modules are not returnable.
- We provide detailed installation instructions, design criteria and technical support upon request.
- When wiring PixelPro Rectangle Modules we recommend injecting power every string, or 20 modules. Simply connect to power on both ends. This significantly reduces any voltage drop problems over the line that would lead to reduced flux far from the driver. Use the power injector plugs to apply power in between each string for best results.
The easy-to-use PixelPro connectors are listed as companion parts, for your convenience.