Accessories-24 Volt RGB LED Neon

LED Neon ends can be terminated and sealed in many different ways using the DIY connector kits we offer in stock or by ordering finished Custom Injection Molded IP68 ends.
  • The DIY options can be IP65 or IP68 by using the sealant glue and heat gun to install the connector kit. All connector joints must be connected correctly to achieve IP65/IP68 rating.
  • Customized Injection Molded Ends are IP68 guaranteed since they are sealed at the factory after being cut to your specified custom lengths. Accordingly, there is a 5-7 week lead time, a minimum order requirement of 60 meters, and the order will be non-cancellable and nonrefundable. Before submitting the custom order, we encourage you to purchase the 1 foot sample kits of the injection molded neon in stock. You can choose from a variety of injection molded sample kits below:

    There are two types of aluminum channel (standard and self-locking) that are compatible with LED Neon. For both versions, simply use screws to mount the channel, then install the LED Neon into the channel. For complete instructions on how to connect your accessories please refer to the LED Neon user manual.
  • Set Descending Direction

    1-12 of 38

    Page:
    1. 1
    2. 2
    3. 3
    4. 4

    Set Descending Direction

    1-12 of 38

    Page:
    1. 1
    2. 2
    3. 3
    4. 4
    To Top