The 12-module kit includes 12 infrared modules, plus a 60-watt adapter and wire nuts and an adapter connector to enable you to wire your system.
These modules (pods) are for backlighting rear DI cavities and you may think of other uses for them. They're suitable for indoor or outdoor installations and they are flexible and easy to position. They contain 3 nodes with 3 LEDs in each node, and the nodes are identical to those used in our 5050 flex strip.
Easy to install: Double-sided 3M foam tape on the back. Just peel and stick. 10 cm (about 4 inches) of wire between modules. Simply cut and splice the wire wherever you like. Modules are made in sets of 50. Because the wire is flexible, you can array your modules around your installation as you wish. If you have dark spots, you can reposition at will. Easy to dim or control using any of our LED dimming drivers, controllers or pulse dimmers. Or use any DMX controller, in conjunction with our DMX-4-5000 or DMX-24-5000 decoders.
- Epoxy-encased plastic package.
- Infrared 850 nm (850 nm wavelength.)
- IP67 waterproof.
- 12 volts DC.
- 0.8 watts ( watts/foot = watts/meter.)
- Length: 1.74 in = 44.2 mm.
- Width: 0.72 in = 18.3 mm.
- Height: 0.36 in = 9.1 mm.
- LED spacing: 0.62 in = 15.7 mm.
- Cuttable between modules.
- IP67, RoHS, CE.
- 50,000 hours expected lifetime.
- Warranty: 3 years limited.
- No Ultra-Violet emissions, so it won't harm your art or documents.
- We use high quality LEDs for maximum color vibrancy, longevity and color rendering. We pay more for our LED components, and you'll benefit from the difference. This is not a commodity product. Quality matters, and the materials, controls, connections and tech support we provide will make your project successful.
- Cut LED modules are not returnable.
- We provide detailed installation instructions, design criteria and technical support upon request.
- When you wire your modules, we recommend you connect power to both ends. This significantly reduces any voltage drop problems over the line that would lead to reduced flux far from the driver. Also, the modules are made in 50-module chains, and you should not link chains. Simply apply power to both ends of each of your chains for best results.
NOTE: InfraRed light is not visible. Do not buy this product for accent lighting or general illumination. It is for special purposes only. Excessive exposure to infrared light may be hazardous. Here is a scientific paper on the hazards
. Infrared LED strips do not dim fully on our voltage-varying dimmers, such as 36W12VDim, 48W24VDim, 60W12VDim, 96W24VDim, 4x60W12VDimX or 3x96W24VDimX. Use a pulse dimmer instead.